Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 2117

vlan-stack trunk Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN network. C9000 Series Syntax vlan-stack trunk To remove a trunk port designation from the selected interface, use the no vlanstack trunk command. Defaults Not configured. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Netowrking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 7.8.1.0 7.7.1.0 7.6.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. C-Series and S-Series accept both bytes of the 2-byte S-Tag TPID. Functionality augmented for C-Series and S-Series to enable multi-purpose use of the port. Functionality augmented for E-Series to enable multipurpose use of the port. Introduced on the C-Series and S-Series. Usage Information Prior to using this command, to place the interface in Layer 2 mode, execute the switchport command. To remove the trunk port designation, first remove the port (using the no member interface command) from all stackable VLAN-enabled VLANs. A VLAN-Stack trunk port is also allowed to be configured as a tagged port and as an untagged port for single-tagged VLANs. When the VLAN-Stack trunk port is also a member of an untagged VLAN, the port must be in Hybrid mode. Refer to portmode hybrid. VLAN Stacking 2117