Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 431

Version 7.8.1.0 7.7.1.0 7.6.1.0 Description Introduced on the S-Series. Introduced on the C-Series. Introduced IPv6 MGBP on the E-Series. Usage Information CAUTION: Dell Networking recommends that you do not change the administrative distance of internal routes. Changing the administrative distances may cause routing table inconsistencies. The higher the administrative distance assigned to a route means that your confidence in that route is low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are treated as internal BGP routes. maximum-paths Configure the maximum number of parallel routes (multipath support) BGP supports. C9000 Series Syntax maximum-paths {ebgp | ibgp} number To return to the default values, enter the no maximum-paths command. Parameters ebgp ibgp number Enter the keyword ebgp to enable multipath support for External BGP routes. Enter the keyword ibgp to enable multipath support for Internal BGP routes. Enter a number as the maximum number of parallel paths. The range is from 2 to 64. Defaults none Command Modes ROUTER BGP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.0.2.0 Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON. Introduced on the S6000. Border Gateway Protocol 431