Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 868

• Entering a text string after the description command overwrites any previous text string that you previously configured as the description. • The shutdown and description commands are the only commands that you can configure on an interface that is a member of a port-channel. • Use the show interfaces description command to display descriptions configured for each interface. Related Commands show interfaces - displays information about an interface. default interface Resets a physical interface to its factory-default settings. C9000 Series Syntax Parameters default interface interface slot/port-range interface slot/ port-range Enter one of the following interface types and port information to specify a single port or a range of ports. To specify a port range, you can enter a hyphenated range and/or individual port numbers separated with commas; for example, default interface tengigabitethernet 1/0-4,7,9-11. To enter any random number of ports, you can enter a comma-separated string of port numbers, for example default interface tengigabitethernet 1/0,1,9,11 • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. Defaults Not configured. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is the Dell Networking OS version history for this command. Version 9.9(0.0) Description Introduced on the C9010, FNXML, MXL, S4810, S4820T, S3048-ON, S4048-ON, S5000, S6000, S6000-ON, and Z9500. Usage Information Use the default interface command to set a 10-Gigabit Ethernet or 40Gigabit Ethernet interface to its factory-default state. By default, a physical 868 Interfaces