Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1016

To return to the default values, use the no isis priority [value] [level-1 | level-2] command. Parameters value level-1 level-2 This value sets the router priority. The higher the value, the higher the priority. The range is from 0 to 127. The default is 64. (OPTIONAL) Specify the priority for Level 1. This setting is the default. (OPTIONAL) Specify the priority for Level 2. Defaults value = 64; level-1 (if not otherwise specified). Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OSCommand Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.5(0.1) 9.0.2.0 8.3.19.0 8.3.12.0 8.3.11.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Usage Information You can configure priorities independently for Level 1 and Level 2. Priorities determine which router on a LAN is the designated router. Priorities are advertised within hellos. The router with the highest priority becomes the designated intermediate system (DIS). NOTE: Routers with a priority of 0 cannot be a designated router. Setting the priority to 0 lowers the chance of this system becoming the DIS, but does not prevent it. If all the routers have priority 0, one with highest MAC address becomes DIS even though its priority is 0. 1016 Intermediate System to Intermediate System (IS-IS)