Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1587

ip pim sparse-mode sg-expiry-timer Enable expiry timers globally for all sources. C9000 Series Syntax ip pim sparse-mode sg-expiry-timer seconds [vrf vrf-name] To disable configured timers and return to default mode, use the no ip pim sparse-mode sg-expiry-timer command. Parameters seconds vrf vrf-name Enter the number of seconds the S, G entries are retained. The range is from 211 to 65535. (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable expiry timer for all sources on that VRF. NOTE: Applies to specific VRF if input is provided, else applies to Default VRF. Defaults Disabled. The default expiry timer (with no times configured) is 210 sec. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.5(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.8.1.0 7.7.1.1 Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON and added support for VRF. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the C-Series for the port-channels and the SSeries. Introduced Usage Information This command configures an expiration timer for all S.G entries, unless they are assigned to an Extended ACL. PIM-Sparse Mode (PIM-SM) 1587