Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 269

Parameters [bytes]] [dscp value] [order] [monitor] [fragments] [log [interval minutes] [threshold-in-msgs [count]] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no deny {ip | ip-protocol-number} {source mask | any | host ip-address} {destination mask | any | host ip-address} command. ip ip-protocolnumber source mask any host ip-address destination count bytes dscp order fragments log Enter the keyword ip to configure a generic IP access list. The keyword ip specifies that the access list denies all IP protocols. Enter a number from 0 to 255 to deny based on the protocol identified in the IP protocol header. Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or noncontiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host then the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter the keyword count to count packets that the filter processes. (OPTIONAL) Enter the keyword byte to count bytes that the filter processes. (OPTIONAL) Enter the keyword dcsp to match to the IP DSCP values. The range is from 0 to 63. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order numbers have a higher priority). If you do not use the keyword order, the ACLs have the lowest order by default (255). Enter the keyword fragments to use ACLs to control packet fragments. (OPTIONAL) Enter the keyword log to include ACL matches in the log. Access Control Lists (ACL) 269