Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 523

set extcommunity rt To set Route Origin community attributes in Route Map, use this feature. C9000 Series Syntax set extcommunity rt {as4 ASN4:NN [non-trans] | ASN:NNNN [nontrans] | IPADDR:NN [non-trans]} [additive] To delete the Route Origin community, use the no set extcommunity command. Parameters as4 ASN4:NN ASN:NNNN IPADDR:NN additive non-trans Enter the keyword as4 then the 4-octet AS specific extended community number in the format ASN4:NN (4byte AS number:2-byte community value). Enter the 2-octet AS specific extended community number in the format ASN:NNNN (2-byte AS number:4-byte community value). Enter the IP address specific extended community in the format IPADDR:NN (4-byte IPv4 Unicast Address:2-byte community value). (OPTIONAL) Enter the keyword additive to add to the existing extended community. (OPTIONAL) Enter the keywords non-trans to indicate a non-transitive BGP extended community. Defaults none Command Modes ROUTE MAP (config-route-map) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.7.1.0 7.6.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T Introduced on the Z-9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Border Gateway Protocol 523