Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 858

• grep - show only text that matches a pattern. • no-more - do not paginate the output. • save - save the output to a file. The following describes the show redundancy command shown in the following example. Field RPM Status Description Displays the following information: • Slot number of the RPM. • Whether the RPM is Primary or Standby. • The state of the RPM: Active, Standby, Booting, or Offline. • Whether the link to the second RPM is up or down. PEER RPM Status RPM Redundancy Configuration Displays the state of the second RPM, if present Displays the following information: • which RPM is the preferred Primary on next boot (the redundancy primary command) • the data sync method configured (the redundancy synchronize command) • the failover type (you cannot change this type; it is software-dependent). Hot Failover means that the running configuration and routing table are applied on secondary RPM. Fast Failover means that the running configuration is not applied on the secondary RPM until failover occurs, and the routing table on line cards is cleared during failover. • the status of auto booting the RPM (the redundancy disable-auto-reboot command) • the parameter for auto failover limit control (the redundancy auto-failover-limit command) RPM Failover Record Displays the following information: • RPM failover counter (to reset the counter, use the redundancy reset-counter command) • the time and date of the last RPM failover • the reason for the last RPM failover Last Data Sync Record Displays the data sync information and the timestamp for the data sync: • Start-up Config is the contents of the startup-config file. • Line Card Config is the line card types configured and interfaces on those line cards. • Runtime Event Log is the contents of the Event log. • Running Config is the current running-config. 858 High Availability (HA)