Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 899

Interfaces The following table describes the show interfaces command shown in the 10G example. Line TenGigabitEthern et 0/0... Hardware is... Pluggable media present... Description Interface type, slot/port, and administrative and line protocol status. Interface hardware information, assigned MAC address, and current address. Present pluggable media wavelength, type, and rate. The error scenarios are: • Wavelength, Non-qualified - Dell Force10 ID is not present, but wavelength information is available from XFP or SFP serial data • Wavelength, F10 unknown-Dell Force10 ID is present, but not able to determine the optics type • Unknown, Non-qualified- if wavelength is reading error, and F10 ID is not present Dell Networking allows unsupported SFP and XFP transceivers to be used, but the system might not be able to retrieve some data about them. In that case, typically when the output of this field is "Pluggable media present, Media type is unknown", the Medium and the XFP/SFP receive power reading data might not be present in the output. Interface index... Internet address... MTU 1554... LineSpeed ARP type:... Displays the interface index number used by SNMP to identify the interface. States whether an IP address is assigned to the interface. If an IP address is assigned, that address is displayed. Displays link and IP MTU information. Displays the interface's line speed, duplex mode, and Slave. Displays the ARP type and the ARP timeout value for the interface. Last clearing... Queuing strategy... Displays the time when the show interfaces counters where cleared. States the packet queuing strategy. FIFO means first in first out. Input Statistics: Displays all the input statistics including: • Number of packets and bytes into the interface • Number of packets with VLAN tagged headers • Packet size and the number of those packets inbound to the interface • Number of Multicast and Broadcast packets: 899