Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 578

Defaults Disabled. Command Modes ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.4.1.0 8.3.19.0 7.8.1.0 7.7.1.0 7.4.1.0 Description Introduced on the C9010. Introduced on the Z9500. Added support for IPv4 multicast and IPv4 unicast address families. Introduced on the S4820T. Introduced on the S4810. Introduced on the C-Series. Introduced Usage Information This command enables soft-reconfiguration for the specified BGP neighbor. BGP stores all updates for inbound IPv6 unicast routes the neighbor receives but does not reset the peer-session. CAUTION: Inbound update storage is a memory-intensive operation. The entire BGP update database from the neighbor is stored in memory regardless of the inbound policy results applied on the neighbor. neighbor subnet Enable passive peering so that the members of the peer group are dynamic. C9000 Series Syntax neighbor peer-group-name subnet subnet-number mask To remove passive peering, use the no neighbor peer-group-name subnet subnet-number mask command. Parameters subnet-number mask Enter a subnet number in dotted decimal format (A.B.C.D.) as the allowable range of addresses included in the peer group. To allow all addresses, enter 0::0/0. Enter a prefix mask in / prefix-length format (/x). Defaults Not configured. Command Modes ROUTER BGP 578 Border Gateway Protocol