Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1748

Example • If no BPDU is received from a remote device, loop guard places the port in a Loop-Inconsistent Blocking state and no traffic is forwarded on the port. On the port extender (PE) ports and on VP-LAGs (LAGs created with PE): • Spanning-tree with BPDU guard shutdown-on-violation is enabled as a default setting. • No spanning tree command is valid. This command is not visible and issuing this command on VP-LAG ports results in a failure. Dell(conf)#interface tengigabitethernet 2/0 Dell(conf-if-te-2/0)#spanning-tree rstp edge-port Dell(conf-if-te-2/0)#show config ! interface TenGigabitEthernet 2/0 no ip address switchport spanning-tree rstp edge-port no shutdown Dell# tc-flush-standard Enable the MAC address flushing after receiving every topology change notification. C9000 Series Syntax tc-flush-standard To disable, use the no tc-flush-standard command. Defaults Disabled Command Modes CONFIGURATION (conf-rstp) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. 1748 Rapid Spanning Tree Protocol (RSTP)