Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1694

match ip access-group Configure match criteria for a class map, based on the access control list (ACL). C9000 Series Syntax match ip access-group access-group-name [set-ip-dscp value] To remove ACL match criteria from a class map, use the no match ip accessgroup access-group-name [set-ip-dscp value] command. Parameters access-groupname set-ip-dscp value Enter the ACL name whose contents are used as the match criteria in determining if packets belong to the class the class-map specifies. (OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP value. The matched traffic is marked with the DSCP value. The range is from 0 to 63. Defaults none Command Modes CLASS-MAP CONFIGURATION (config-class-map) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.11.1 8.3.7.0 7.7.1.0 7.6.1.0 7.5.1.0 7.5.1.0 6.1.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the Z9000. Introduced on the S4810. Added the DSCP Marking option support on the S-Series. Introduced on the S-Series. Introduced on the C-Series. Added support for the DSCP Marking option. Introduced on the E-Series. Usage Information To access this command, enter the class-map command. After the class map is identified, you can configure the match criteria. For class-map match-any, a maximum of five ACL match criteria are allowed. For class-map match-all, only one ACL match criteria is allowed. 1694 Quality of Service (QoS)