Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1424

Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 7.5.1.0 6.1.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced to all platforms. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information To enable OSPF on an interface, the network area command must include, in its range of addresses, the primary IP address of an interface. NOTE: An interface can be attached only to a single OSPF area. If you delete all the network area commands for Area 0, the show ip ospf command output does not list Area 0. passive-interface Suppress both receiving and sending routing updates on an interface. C9000 Series Syntax passive-interface {default | interface} To enable both the receiving and sending routing, use the no passiveinterface interface command. To return all OSPF interfaces (current and future) to active, use the no passiveinterface default command. Parameters default interface Enter the keyword default to make all OSPF interfaces (current and future) passive. Enter the following keywords and slot/port or number information: • For Port Channel groups, enter the keywords portchannel then a number. The range is from 1 to 128. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. 1424 Open Shortest Path First (OSPFv2 and OSPFv3)