Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1517

interactive testname name terminate the board are put into Loopback mode and test packets are transmitted through those components. These diagnostics also perform snake tests using VLAN configurations. Enter the keyword interactive to run offline diagnostics in interactive mode. NOTE: On a C1048P, interactive diagnostic tests are supported only in standalone mode; they are not supported in stacking mode. Enter the testname name parameters to run a specified offline diagnostic test. Enclose the test-case name in double quotes (" "). For example: diag level1 testname "first". Enter the keyword terminate to stop the offline diagnostic tests that are running. Defaults All offline diagnostic tests are run on all switch CPUs (Control Processor, Route Processor, and line cards). Command Modes EXEC Privilege Usage Information Before you use this command to run diagnostic test, make sure that the port extender (PE) stack-unit is offline (offline stack-unitunit number command). You are prompted to reboot when the offline diagnostics is complete. The PE unit goes offline and reboots automatically after the test is completed. Once the test is finished, the diag report is generated, and it is stored in the PE flash. To view the diag report, use the show diag pe pe-id stack-unit unit-number command from C9000 system. The show diag pe command uploads the TestReport from the PE to the C9000. The filename of the TestReport is:TestReport-SU-Stack-Unit-Number-PEpe-id-Year_Month_Day_Unique-Tag.txt, where SU identifies the PE stackunit on which the offline diag test was run, Year_Month_Day is a timestamp to identify when the offline diag test was run for that unit, and the Unique Tag is to identify that specific diag test. Diag test reports on PE are not overwritten. Offline diag test reports for PE are stored in the following directory: flash:// default_diag_report_dir. To view the test report, use the show file flash://filename command. Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) Description Introduced on C9010 and C1048P. Introduced on the Z9500. PE Console Commands 1517