Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1905

Version 9.9(0.0) 9.7(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 8.1.1.0 7.7.1.0 7.6.1.0 6.2.1.1 Description Introduced on the C9010. Introduced on the S6000-ON. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on S-Series Stacking. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information This command changes the sampling rate for an interface. By default, the sampling rate of an interface is set to the same value as the current global default sampling rate if port is operationally down, otherwise sampling rate changes based on port line speed. If the value entered is not a correct power of 2, the command generates an error message with the previous and next power-of-2 value. Select one of these two number and re-enter the command. Related Commands sflow sample-rate (Global) - changes the sampling rate globally. show sflow Display the current sFlow configuration. Syntax Parameters show sflow [interface] interface (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a Loopback interface, enter the keyword loopback then a number from 0 to 16383. • For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port information. • For a port channel interface, enter the keywords portchannel then a number. • For a 100/1000 Ethernet interface, enter the keyword GigabitEthernet then the slot/port information. sFlow 1905