Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1457

• For loopback interfaces, enter the keyword loopback then a number from 0 to 16383. • For tunnel interfaces, enter the keyword tunnel then a number from 0 to 16383. • For Port Channel groups, enter the keywords portchannel then a number. The range is from 1 to 128. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a VLAN, enter the keyword vlan then the VLAN ID. The range is from 1 to 4094. Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.4(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 7.5.1.0 6.1.1.1 Description Introduced on the C9010. Added support for VRF on all platforms (Except MXL and STOMP). Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added support for Multi-Process OSPF. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The following describes the show ip ospf process-id interface command shown in the following example. Item Description TenGigabitEthern This line identifies the interface type slot/port and the status et... of the OSPF protocol on that interface. Internet Address... This line displays the IP address, network mask and area assigned to this interface. Open Shortest Path First (OSPFv2 and OSPFv3) 1457