Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 1014

2 supportFtp supportFtp Sets, clears, or displays support FTP parameters and enables or disables auto file transfer. SYNOPSIS supportftp [-S] supportftp -s [-h host][-u username][-p password] [-d remotedirectory] [-l protocol] supportftp -t hours supportftp -R supportftp -e supportftp -d DESCRIPTION NOTES OPERANDS Use this command to set, clear, or display supportFtp parameters. The parameters set by this command are used by the supportSave and traceDump commands. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command has the following operands: -S Displays the current syppportFtp parameters. -s Sets the syppportFtp parameters. The following operands are optional. If the -s option is specified without further operands, the command interactively prompts for these parameters. -h host Specifies the host. Provide an IP address or a server name. IPv4 and IPv6 addresses are supported. To specify the host by name, a DNS entry must exist for the server. -u username Specifies the user name. The user name must be less than 48 characters long. -p password Specifies the account password. The password must be less than 48 characters long. When using anonymous FTP, a password is not required. -d remotedirectory Specifies the remote directory where the trace dump files are stored. The directory name must be less than 48 characters long. Specifying the root directory as the remote directory (/) is not allowed. -l protocol Specifies the transfer protocol. Valid values are file transfer protocol (FTP), secure copy protocol (SCP), or secure FTP (SFTP). -t hours Specifies the time interval, in units of hours, at which the server connectivity is checked. 986 Fabric OS Command Reference 53-1002746-01