Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 885
portTest, This command supports E_Ports, F_Ports must support ELS Echo, L_Port
View all Dell Brocade 6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 885 highlights
portTest 2 portTest Performs a functional test of a switch in a live fabric. SYNOPSIS porttest [-ports itemlist] [-iteration count] [-userdelay time] [-timeout time] [-pattern pattern] [-patsize size] [-seed seed] [-listtype porttype] DESCRIPTION Use this command to isolate problems in a single replaceable element and to trace problems to near-end terminal equipment, far-end terminal equipment, or the transmission line. You can perform this test on a daily basis or as needed to verify the persistence of failures detected earlier. This command verifies the functional operation of the switch by sending frames from a port's transmitter, and looping the frames back through an external fiber cable into the port's receiver. The test exercises all switch components from the main board, to the fibre cable, to the media (of the devices and the switch), and back to the main board. The cables and media connected should be of the same type: a short-wavelength media (switch) port should be connected to another short-wavelength media (device) port using a short-wavelength cable; a long-wavelength port should be connected to a long-wavelength port, and a copper port should be connected to a copper port. Only one frame is transmitted and received at any given time. The port LEDs flicker green while the test is running. This command supports E_Ports, F_Ports (must support ELS Echo), L_Port, and N->N loopback ports. In addition, on switches running Fabric OS v6.4.0 and later, you can now use portTest on port configurations that previously caused nonspecific test results or were skipped by portTest. The following ports are now support the portTest diagnostics. • Ports with index numbers greater than 255. • Ports with swapped areas. • Ports in shared area regions. • Ports in logical switches. • Ports in Base Switches. • Long Distance ports. This command is currently not supported on the following ports or switch configurations: • Interchassis links (ICL) ports • F_Ports connected to an Access Gateway • EX_Ports • E_Ports connected to EX_Ports • The portTest diagnostics is not supported in Access Gateway mode. This command performs the following operations: 1. Initiates tests on certain ports (portTest command). 2. Stops active tests on certain ports (stopPortTest command). 3. Takes a snapshot of the test result (portTestShow command). Fabric OS Command Reference 857 53-1002746-01