Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 1104
turboramtest, passcnt, CTRL-C, chassisDisable, turboramtest -passcnt 2
View all Dell Brocade 6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1104 highlights
2 turboRamTest turboRamTest Performs a turbo SRAM test of ASIC chips. SYNOPSIS turboramtest [--slot slot] [-passcnt count] ceeturboramtest [--slot slot] [-passcnt count] DESCRIPTION NOTES Use this command to verify the chip SRAM located in the ASIC using the turbo-RAM BIST circuitry. The BIST controller is able to perform the SRAM write and read operation at a much faster rate than the PCI operation. The turboRamTest and ceeTurboRamTest commands are platform-specific versions of the same test. The turboRamTest command is supported on all Goldeneye2 and Condor-based platforms. Use ceeTurboRamTest on FCoE platforms only. On all other supported platforms, use turboramtest. Refer to the Fabric OS Troubleshooting and Diagnostics Guide, Appendix A, for a table that correlates ASIC type with switch models. Do not abort this test prematurely, using CTRL-C or q to quit. Doing so may cause the test to report unexpected errors. Errors may vary depending on the hardware platform. On 10 Gbps or 16 Gbps (Condor3-based) platforms, you cannot interrupt the test by pressing the return key (). The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This diagnostic cannot be run on an operational switch. You must disable the switch using the chassisDisable command before you can run this test. After the test completes, re-enable the switch using the chassisEnable command. OPERANDS EXAMPLES This command has the following optional operands: --slot slot Specifies the slot number on which the diagnostic operates. All eligible blade ports in the specified slot are tested. This operand is optional. The default value is 0 and operates on fixed port count products. -passcnt count Specifies the number of times to perform this test. This operand is optional. The default value is 1. To run the SRAM test with two passes: switch:admin> turboramtest -passcnt 2 Running turboramtest PASSED. 1076 Fabric OS Command Reference 53-1002746-01