Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 139

cfgSave 2 cfgSave Saves the zone configuration to nonvolatile memory. SYNOPSIS cfgsave DESCRIPTION NOTES OPERANDS EXAMPLES Use this command to save the current zone configuration. This command writes the defined configuration and the name of the effective configuration to nonvolatile memory in all switches in the fabric. The saved configuration is automatically reloaded at power on, and, if a configuration was in effect at the time it was saved, the same configuration is reinstalled with an automatic cfgEnable command. Because the saved configuration is reloaded at power on, only valid configurations are saved. The cfgSave command validates the effective configuration by performing the same tests as the cfgEnable command. If the tests fail, an error message is displayed and the configuration is not saved. This command ends and commits the current transaction. If a transaction is open on a different switch in the fabric when this command is run, the transaction on the other switch is automatically aborted. A message displays on the other switches to indicate that the transaction was aborted. If there are open transactions in the fabric, only single transaction can be saved. Use the cfgtransshow --opentrans command to view the list of all the domains in the fabric with open transactions. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. When an FCS policy is enabled, this command can be issued only from the primary FCS switch. None To save a zone configuration: switch:admin> cfgsave You are about to save the Defined zoning configuration. This action will only save the changes on Defined configuration. Any changes made on the Effective configuration will not take effect until it is re-enabled. Until the Effective configuration is re-enabled, merging new switches into the fabric is not recommended and may cause unpredictable results with the potential of mismatched Effective Zoning configurations. Do you want to save Defined zoning configuration only? (yes, y, no, n): [no]y To save a zone configuration if there are multiple open transactions: switch:admin> cfgsave You are about to save the Defined zoning configuration. This action will only save the changes on Defined configuration. Multiple open transactions are pending in this fabric. Only one transaction can be saved.Please abort all unwanted transactions using the cfgtransabort command. Use the cfgtransshow --opentrans command to display a list of domains with open transactions Do you want to save the Defined zoning configuration only? (yes, y, no, n): [no] n switch:admin> cfgtransabort 271010736 Fabric OS Command Reference 111 53-1002746-01