Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 1067

sysMonitor 2 -action actions Specifies the actions triggered by a configured event condition. Valid values include one or more of the following actions. If more than one action is specified, the actions must be separated by commas. To change the existing configuration of actions, you must first issue the command with the none option to reset the existing configuration, and then reissue the command with the new configuration of actions. snmp Event triggers an SNMP trap. raslog Event triggers a RASlog message. email Event triggers an e-mail. none Event triggers no action. -buffer value Specifies the buffer value for in-range behavior. A buffer defines a zone within which event criteria are met, rather than a single threshold value. This operand is optional with the -trigger options and valid only with these options. -nosave Prevents the configuration changes from being saved persistently. This option allows you to make and view changes without overwriting the saved configuration. When you use --config with the -nosave option and the switch reboots your changes will be lost. --apply Applies the custom or default configuration for thresholds, actions, or both. This command allows you to choose between custom and default settings. The specified configuration takes effect upon execution of this command. When you select custom, the saved configuration becomes effective. --cancel Cancels a nonpersistent configurations. This command effectively undoes the -nosave operation without reboot. You must always specify a class and area when you apply or cancel a configuration. Thresholds and alarm levels are optional; if omitted, all nonpersistent configurations for the specified class and area are used. --pause | --continue arguments Pauses or resumes monitoring. The following arguments are required: class Specifies the class. -area area[,area]... | all Specifies the area. You can either specify one or more areas separated by a comma, or you can specify all to indicate all areas. -index index | all Specifies the index number for the element to be monitored, or specify -index all to indicate all elements. An element is a subcomponent of an area, for example, a temperature sensor on the switch. --show Displays the Fabric Watch configuration for the specified class. When used without operands, this command displays the current Fabric Watch configuration for all classes and areas. When used with optional arguments, the output displays partial views or status information. Fabric OS Command Reference 53-1002746-01 1039