Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 242

2 cryptoCfg -include_mirror Initiates a manual rekey operation on all primary LUNs and mirror LUNs in read-only state. In addition, this command also starts a manual rekey operation on all primary and nonreplicated LUNs in read-write state. --resume_rekey Resumes a suspended rekey session for a specified disk LUN at the termination point. A rekey session may terminate prematurely due to unrecoverable medium or hardware errors. When a rekey session terminates prematurely, the system logs CRITICAL RASlog and rekey operation failure status messages. You must take corrective action to clear all error conditions that caused the rekey failure before resuming a suspended rekey session. All DEK or HA cluster members must be online and reachable for this operation to succeed. crypto_target_container_name Specifies the name of the CTC to which the LUN belongs. LUN_Num Specifies the number of the LUN to be rekeyed. Use the --show -container command for a list of LUN numbers associated with the specified CTC. initiator_PWWN Specifies the initiator port WWN for the specified LUN. --discoverLUN Performs LUN discovery. This command discovers and displays all LUNs that are discoverable by the initiators of a specified CTC. This command is valid only on the node that hosts the CTC. The following operand is required: crypto_target_container_name Specifies the name of the CTC. --show -container Displays all CTCs in the encryption group. This command is valid on all nodes. The following operands are supported: -all -cfg Displays the configuration for all containers in the encryption group. -all -stat Displays the runtime status for all containers hosted on the local node only. crypto_target_container_name Displays information for the specified CryptoTarget container. If the -stat parameter is specified with this operand, the CTC must be hosted on the local node. -cfg Displays the configuration for the specified CTC. -stat Displays the runtime status for the specified CTC. --show -tapepool Displays configuration information for specified tape pools when used with the -cfg option. Displays runtime status information for specified tape pools when used with the -cfg option. This command is valid on all nodes. The following operands are supported: -all -cfg Displays configuration information for all configured tape pools in the encryption group. 214 Fabric OS Command Reference 53-1002746-01