Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 987

snmpConfig 2 --set Sets the SNMP agent configuration data of the specified category. This operand displays the current settings and then prompts you to change the values for each parameter. --default Sets the SNMP agent configuration data for a specified item to the default values. Generally, these default values may be available in the configuration database. The command sets to factory defaults if the SNMP agent configuration parameters are not available in the configuration database. --enable Enables the SNMP agent configuration for the specified category. This operand is valid only with mibCapability and snmpv1. When used with the snmpv1 operand, this command restores access to SNMPv1/v2c. --disable Disables the SNMP agent configuration for the specified category. This operand is valid only with mibCapability and snmpv1. When used with the snmpv1 operand, this command blocks access to SNMPv1/v2c. All requests for v1/v2c version will be dropped by the switch, and SNMPv1 traps will be blocked from being sent, even if trap destinations are present. snmpv1 Selects SNMPv1-related configuration parameters. These parameters include the community string, trap recipient IP address, and trap severity level associated with each trap recipient IP address. When "0" is configured as a trap port, traps can be received at the default port 162. snmpv3 Selects SNMPv3-related configuration parameters. These parameters include the user name, authentication protocol and password, the privacy protocol and password, the SNMPv3 trap recipient's IP address, its associated user index and trap severity level. When "0" is configured as a trap port, traps can be received at the default port 162. The --set snmpv3 command supports an interactive option to enable or disable informs by setting the parameter "SNMP Informs Enabled" to true or false. If informs are enabled, all trap destinations receive inform requests. If informs are disabled, all trap destinations receive trap requests. When informs are enabled, the engine ID must be set to correspond to the management engine IP address (see example). Informs are by default disabled. IPv6 Informs are currently not supported. accessControl Selects access-control-related parameters. These parameters include the access host subnet area and access permission (read-write). mibCapability Selects configuration parameters related to the SNMP agent's MIBs and trap capability parameters. These parameters include MIBs and traps supported by the SNMP agent. systemGroup Selects configuration parameters related to the system group. These parameters include sysDescr, sysLocation, sysContact, and authentication failure trap. secLevel Sets the SNMP security level. Fabric OS Command Reference 959 53-1002746-01