Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 346
fcpRlsProbe, fcpRlsProbe --start, con start
View all Dell Brocade 6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 346 highlights
2 fcpRlsProbe fcpRlsProbe Initiates the Fibre Channel Protocol (FCP) Read Link Status (RLS) probing for F_Port and displays the RLS information. SYNOPSIS fcpRlsProbe --start [slot/]port_list fcpRlsProbe --show [slot/]port fcpRlsProbe --help DESCRIPTION NOTES OPERANDS EXAMPLES Use this command to initiate the FCP RLS probing or to display the RLS information. This information describes the number of link failures, loss-of-signal, loss-of-sync, CRC errors, and other failure events detected on the specified port. Use the fcprlsprobe --start command to read the error status block for F/FL-Ports. This command will send a RLS ELS probe to the device on the specified port and caches the RLS information. Use the fcprlsprobe --show command to display the cached RLS information. For the command to send RLS probe to the device you must enable the following parameter: Disable Device Probing = 0 (Enables device probing. By default Device probing is enabled). For this command to gather and display F_Port error statistics, apart from enabling the device probing, you must enable RLS Probing using the fcprlsprobe --start command or use the configure command, "Disable RLS Probing". By default, RLS probing is disabled. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command has the following operands: slot Specifies the slot number, if applicable, followed by a slash (/). port_list Specifies a port number. You can specify a port or range of ports. --start Sends the ELS RLS to the device and gets the RLS information. --show Displays the RLS information. --help Displays the command usage. To start the RLS probing: switch:admin> fcprlsprobe --start 1 RLS probing initiated... Please use the fcprlsprobe --show port command to view the RLS info. To view the RLS information: switch:admin> fcprlsprobe --show 1 Rls Probing Statistics for port 1 AL_PA 0x0 --------RLS Probe Status : SUCCESS 318 Fabric OS Command Reference 53-1002746-01