Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 675

portCfg 2 mgmtif Configures an inband management interface. A maximum of one interface is supported per GbE Port. Up to a total of 6 management interfaces are supported for the Brocade 7800 and up to a total of 11 interfaces for the Brocade FX8-24 (depending on blade operating mode). The interfaces must each exist on a unique network, separate from the other inband management interfaces and from all other interfaces on the CP. The syntax for mgmtif is as follows: mgmtif ge_port [options] arguments Valid options and arguments for mgmtif include the following: create Creates a specified IP Address for the inband management interface. The IP address must be unique. IPv4_address Specifies an IP address for the inband management interface in IPv4 format, followed by the subnet mask. netmask Specifies the subnet mask for the IPv4 address in a.b.c.d format. MTU Specifies the MTU for the inband management interface. The valid range is 1260 to 1500. This operand is optional. delete Deletes the specified IP Address for the inband management interface. IPv4_address Specifies the IP address to be deleted. disable Disables the inband management interface at the specified GbE Port. enable Re-enables the inband management interface at the specified GbE Port after it has been disabled. The interface is by default enabled when it is created. mgmtroute Configures the management route for the inband management interface (needed only if the management interfaces are on different subnets). The syntax for mgmtroute is as follows: mgmtroute ge_port [options] destination_ip_address Valid options and arguments for mgmtroute include the following: create Creates a management route for a specified destination IP Address. The following operands are required: dest_IPv4_addr Specifies the destination IP address for the management route in IPv4 format. netmask Specifies the subnet mask for the IPv4 address in a.b.c.d format. gateway Specifies the IP address of an IP router that can route packets to the destination IP address. Fabric OS Command Reference 647 53-1002746-01