Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 733
switchShow, disable, csctl_mode, enable, resetratelimit, default, portcfgqos --enable 1/15
View all Dell Brocade 6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 733 highlights
portCfgQoS 2 OPERANDS EXAMPLES This command has the following operands: slot For bladed systems only, specifies the slot number of the port to configure, followed by a slash (/). port[-port] Specifies the port or port range to be configured, relative to the slot for bladed systems. Use switchShow for a listing of valid ports. You can specify a port range only when you configure CS_CTL-based traffic prioritization. --disable Disables the current configuration on the specified ports. When issued for a single port, this command disables QoS, which is enabled by default. When issued with the csctl_mode operand, this command accepts a port range and disables traffic prioritization based on CS_CTL. If QoS was enabled before you enabled csctl_mode, this command restores QoS-based traffic prioritization. --enable Enables QoS or CS_CTL mode. When issued for a single port, this command enables QoS. When issued with the csctl_mode operand, this command accepts a port range and enables traffic prioritization based on CS_CTL. If QoS is enabled when you enable csctl_mode, the command displays a message stating that QoS zones will lose priority to CS_CTL-based traffic prioritization. --resetratelimit Turns off the ingress rate limiting feature on the specified port. --setratelimit ratelimit Sets an ingress rate limit to reduce traffic from the specified port. This configuration is applicable only to F/FL_Ports. For E/EX_Ports, this configuration would not be effective. The ingress rate limit is enforced only when a given port can run at a speed higher than the speed specified in the configuration. For example if the rate limit is set at 4 Gbps and the port comes online only at 2 Gbps, no enforcement is needed. Specify an ingress rate in Mbps. Supported values for ratelimit are: 200, 400, 600, 800, 1000, 1500, 2000, 2500, 3000, 3500, 4000, 5000, 6000, 7000, and 8000, 9000, 10000, 11000, 12000, 13000, 14000, 15000, 16000. --default Applies the default configuration to the specified port. This command attempts to re-enable QoS; success depends on availability of buffers. If CS_CTL was enabled on the port, this command disables the configuration. --help Displays the command usage. To enable QoS on a port. switch:admin> portcfgqos --enable 1/15 To disable QoS on a port. switch:admin> portcfgqos --disable 1/15 To set the default QoS configuration on a port: switch:admin> portcfgqos --default 12/41 To set the ingress rate limit on a port to 2 Gbps: switch:admin> portcfgqos --setratelimit 12/41 2000 Fabric OS Command Reference 705 53-1002746-01