Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 830

2 portShow --lifetime Displays the entire lifetime statistics for FCIP Tunnels, Circuits and the associated TCP connections. This option will ignore any time based deltas that were created previously set using the --reset option. -q | --qos Displays the QoS statistics including performance for each priority. This operand is optional with the --perf option. -i | --ipsec Displays IPSec status (enabled or disabled) and key if enabled. If IPSec is enabled and configured in legacy mode, the mode information is displayed in parenthesis. This option is valid for portShow fciptunnel only. -h | --hier Displays the FCIP tunnel hierarchy listing basic circuit IDs and TCP connection information for the tunnel. -s | --summary Displays a summary view of the tunnel configuration parameters for a specific VE_Port. You can use the summary option with the -perf and the - qos option. When used with the -perf option, the summary option forces the --circuit option. Flags indicate ipsec-configured tunnels, legacy ipsec tunnels, and compression mode. Circuit flags indicate vlan tagging, crossport configuration, and ipv4 or ipv6 configuration. -d | --detail Displays a full view configuration details for all configured tunnels when used with the all port specifier. This view provides an alternative to specifying a specific VE_Port or to using the --perf option for a comprehensive view. -I | --ip-address Displays the IP addresses configured the specified circuits. You must use this option with either the --summary or the --circuit option. fcipcircuit Displays FCIP circuit configuration and status. The following operands are supported with portShow fcipcircuit: circuit_ID Specifies a single circuit within the FCIP tunnel. The circuit ID is an integer value between 1 and 19 on the Brocade FX8-24 and 1 and 7 on the Brocade 7800. This operand is required. -t | --tcp Displays the TCP statistics for the specified circuit. --reset Displays time based set of statistics. --lifetime Displays the entire lifetime statistics for FCIP Tunnels, Circuits and the associated TCP connections. This option will ignore any time based deltas that were created previously set using the --reset option. -p | --perf Displays additional performance information for the specified FCIP circuit. --lifetime Displays the entire lifetime statistics for FCIP Tunnels, Circuits and the associated TCP connections. This option will ignore any time based deltas that were created previously set using the --reset option. 802 Fabric OS Command Reference 53-1002746-01