Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 555

lsCfg 2 -b | -base Creates a base logical switch on the chassis. A base logical switch communicates among different logical switches. Legacy switches can be connected to the base logical switch through EX_Ports, and interswitch links (ISLs) between base logical switches enable communication among different logical switches. This operand is optional. -f | -force Executes the command without confirmation. This operand is optional. --delete Deletes a logical switch with the specified fabric ID. The specified logical switch must exist and no ports should be configured on this partition. You must remove all ports from the logical switch before deleting the logical switch instance. Use the lscfg --config command to remove the ports. FID Specifies the Fabric ID of the logical switch. This operand is required. --config Configures the specified logical switch. This command assigns ports to the logical switch specified by a given FID. The ports are removed from the partition on which they are currently configured. This command prompts for confirmation, indicating that the specified ports will be disabled. The following operands are supported: FID Specifies the fabric ID of the logical switch. This operand is required. -slot slot1[-slot2] Specifies the slot number or a range of slot numbers separated by a dash, for example -slot 3-5. This operand is required. -port port1[-port2] Specifies the ports to be assigned to the logical switch. Provide a valid port, or a range of ports separated by a dash, for example -port 3-8. This operand is optional; if omitted, all ports on the specified slots are assigned. -f | -force Executes the command without confirmation. This operand is optional. --restore_to_default FID Moves all vacant ports in the logical switch specified by FID to the default switch. Use this command when lsCfg --show displays no ports, but the switch continues to generate errors indicating that there are ports on the switch. --restore_slot_to_default slot Moves all ports on a specified slot to the default switch. --change Changes the fabric ID of a logical switch, creates a base logical switch out of an existing logical switch, or removes base switch properties. The -newfid and -base operands are exclusive and may not be combined. The following operands are supported: FID Specifies the Fabric ID of the logical switch. This operand is required. -n | -newfid FID Changes the fabric ID of an existing logical switch. This command effectively removes the logical switch from a given logical fabric and makes it part of another logical fabric. Fabric OS Command Reference 527 53-1002746-01