Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 215

cryptoCfg 2 --set -quorumsize Sets the quorum size used to authenticate functions that require a quorum of authentication cards. The default value is zero. You can set the quorum size only if the current value is zero. Note that this value is different from the recovery set size that specifies the number of recovery shares used to perform Master Key recovery. When quorum authentication is enabled (Quorum Size is > 0), this operation requires authentication of a quorum of authentication cards. value Specifies the quorum size. Valid values are 0 (quorum authentication is disabled) and 1 through 5 (quorum authentication is enabled). This operand is required. --set -systemcard> enable | disable Enables or disables the system card usage policy. When the policy is enabled, a system card is required to be inserted in an encryption engine to enable encryption after a power-cycle event. When quorum authentication is enabled (Quorum Size is > 0), this operation requires authentication of a quorum of authentication cards. The policy is disabled by default. This command must be executed on the group leader. --set -replication enable | disable Enables or disables replication-specific features. You must enable replication before you can use replication-specific features such as the -newLUN, -include_mirror, or the --refreshDEK command. Replication is disabled by default; it must be enabled on the group leader. This command is supported only for the DPM key vault. --add -membernode Adds the specified member node to the existing encryption group. The member node is specified by its node WWN. This command is valid only on the group leader. Initial setup on the node must be performed prior to adding the node to an encryption group. This command is required only when a node that was earlier part of encryption group (online and DISCOVERED) was ejected or left the encryption group and is now added back to that encryption group. A member node that is online during registration is added automatically to the encryption group. The following operand is required: node_WWN Specifies the WWN of the node to be added back to the encryption group. --eject -membernode Removes a member node from the existing encryption group. The node is specified by its node WWN. This command is valid only on the group leader. The node must be online (in DISCOVERED state) for this command to succeed. To remove a node that is not online (in DISCOVERING State), use the --dereg -membernode command. You must remove the EEs from the HA cluster and delete any Crypto Target container/LUN configurations from this node before ejecting the node or the command fails. The following operand is required when ejecting a member node: node_WWN Specifies the node WWN of the node to be removed from the encryption group. --leave_encryption_group Clears the node's states pertaining to the node's membership in the encryption group. This command is invoked from the member node that is to be ejected from the encryption group. Fabric OS Command Reference 187 53-1002746-01