Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 87

auditCfg 2 auditCfg Modifies and displays the audit log filter configuration. SYNOPSIS auditcfg --class audit_class auditcfg --enable | --disable auditcfg --severity severity_level auditcfg --show DESCRIPTION NOTES OPERANDS Use this command to configure the audit logging and to display the audit log configuration. This command allows you to set filters by configuring certain classes, to add or remove any of the classes in the filter list, to set severity levels for audit messages, and to enable or disable audit filters. Based on the configuration, certain classes are logged to syslog for auditing. Syslog configuration is required for logging audit messages. Use the syslogdIpAdd command to add the syslogd server IP address. The MAPS class is for internal use only. The RAS class is not configurable; its function is to audit the audit log management operations and it is always enabled internally. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command has the following operands: --class Configures filters for a specified audit class. To add or remove any of the classes in the filter list, reissue the --class option. audit_class Specifies the filters to be configured. Valid values are: 1-ZONE, 2-SECURITY, 3-CONFIGURATION, 4-FIRMWARE, 5-FABRIC, 6-FW (Fabric Watch), and 7-LS (Logical Switch), 8-CLI, 9-MAPS (internal use only). The filter is specified by its numeric value. To add more than one filter, the numeric values must be separated by commas. Spaces are not permitted. This operand is required. --severity Sets audit severity level to a specified value. When severity is set, only log messages of type severity_level and higher are displayed. You cannot enter multiple severity levels. severity_level Valid values are INFO, WARNING, ERROR, and CRITICAL. By default, all messages are logged. This operand is required. --enable Enables all filters. This action enables an existing configuration; it does not change the configuration. --disable Disables all filters.This action disables an existing configuration; it does not change the configuration. --show Displays the current configuration. This operand is optional. Fabric OS Command Reference 59 53-1002746-01