Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 1076

2 thConfig NOTES OPERANDS Monitoring of Condor 3-based 10G SFPs, 16G SFPs, and 16G QSFPs (quad small form-factor pluggables) is by default disabled. Use the thMonitor command to enable monitoring of these advanced SFPs. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. The Fabric and Security classes are not supported in Access Gateway mode. This command has the following operands: class Specifies a Fabric Watch class to be monitored. This operand is optional with the --show option and required with all configuration options. -area area Specifies the area that can be configured for a specified class. This operand is optional with the --show option and required with all configuration options. Areas are specific to each class. The following classes and associated areas are configurable with the thConfig command. Classes and areas are not case sensitive. SFP Monitors the SFP class. When used with the -sfptype option on Condor 3-based platforms, thresholds configured for the SFP class apply to 16G SFPs, 10G SFPs, and 16G QSFPs. Valid areas for the SFP class include the following: TEMP Monitors the physical temperature of the SFP in degrees Celsius. For 16G QSFPs, Fabric Watch monitors temperature only on the first QSFP port that is available on the (logical) switch. RXP Measures Receive Power for the SPF in Watts. TXP Measures Transmit Power for the SPF in Watts (not supported on 16G QSFPs). CURRENT Measures the amount of current supplied to the SFP transceiver. VOLTAGE Measures the amount of voltage supplied to the SFP. For 16G QSFPs, Fabric Watch monitors voltage only on the first QSFP port that is available on the (logical) switch. ST Measures the number of SFP state changes This area is deprecated as of Fabric OS v7.0. To configure SFP State Changes, use the fwFruCfg command. PWRONHRS Measures the number of operational hours (power-on hours) for the SFP. This class is supported only for 16G SFPs and QSFPs (Condor 3 ASIC), and the only valid time base for this class is none. You can display the power-on hours with the sfpShow command. FABRIC Monitors the Fabric class. Valid areas for the Fabric class include the following: ED Tracks the number of times an E_Port or VE_Port goes down. 1048 Fabric OS Command Reference 53-1002746-01