Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 203

cryptoCfg 2 Files to be imported include member node CP certificates and key vault certificates. Use the cryptocfg --show -file -all command to view all imported files. The following operands are supported with the --importcommand: -scp Imports a specified certificate from an external host using the secure copy (SCP) protocol. When -scp is specified, the following operands are required: local_name Specifies the name to be assigned to the imported certificate. This is a user-generated file name. host_IP | host_name Specifies the IP address or name of the host from which to import the file. To specify the host by name, it must first be configured with the dnscCnfig command. host_username Specifies the user name for the host. Depending on your host configuration, this command may prompt for a password. host_file_path Specifies the fully qualified path of the file to be imported. The path must include the file name. -usb Imports a file from a mounted USB storage device. This command is valid only on nodes with an attached USB device. When -usb is specified, the following operands are required: dest_filename Specifies the name to be assigned to the imported file. This is a user-generated file name. source_filename Specifies the name of the certificate on the USB storage device from which you are importing. --reg -membernode Registers a member node with the group leader. This command is valid only on the group leader. The encryption group must have been created prior to performing member node registration. All member nodes and group leaders must be registered before encryption group discovery and formation can occur. The order in which member node registration is performed defines group leader succession. At any given time, there is only one active group leader in an encryption group. The group leader succession list Specifies the order in which group leadership is assumed if the current group leader is not available. The following operands are required when registering a member node with the group leader: member_node_WWN Specifies the switch world wide name of the member node. member_node_certfile Specifies the member node CP certificate. You must have exported this file earlier to external storage and then imported it to the group leader before you can register a member node. Use the cryptocfg --show -file -all command to view all imported certificates. member_node_IP_add Specifies the IP address of the member node to be registered with the group leader. Fabric OS Command Reference 175 53-1002746-01