Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 492

2 ipAddrSet ipAddrSet Sets the Ethernet and FC IP addresses. SYNOPSIS ipaddrset [-ipv6 ] [--add x:x:x:x:x:x:x/n | --delete] ipaddrset [-cp cp_number | -chassis] [-ipv6 ] [--add x:x:x:x:x:x:x/n | --delete] ipaddrset [-slot slot] [-eth0 | -eth1] [--add x.x.x.x/n | --delete] ipaddrset [-slot slot] -gate [--add x.x.x.x | --delete] ipaddrset -ls FID --add IPv4_address/prefix ipaddrset -ls FID --delete ipaddrset -ipv6 [-auto | -noauto] ipaddrset [-cp cp_number | -chassis] ipaddrset -cp cp_number -ipv4 -add -host hostname -ethip ipaddress -ethmask mask -gwyip gateway_ip ipaddrset -ipv4 -add -ethip ipaddress -ethmask mask -gwyip gateway_ip -dhcp [ON | OFF] ipaddrset -chassis -ipv4 -add -ethip ipaddress -ethmask mask ipaddrset -ipv6 [-dhcpv6 | -nodhcpv6] ipaddrset --help DESCRIPTION Use this command to configure the IP addresses on a switch, a control processor (CP), a blade processor (BP), or a standalone application processor (AP). On platforms that support Logical Fabrics, this command configures the IPv4 Fibre Channel addresses for the logical fabric IPFC network interface. The IPFC (IP over Fibre Channel) protocol allows switches to send IP traffic over Fibre Channel rather than through Ethernet connections. This command supports an interactive legacy mode and a command line interface. Use the command line interface to configure IPv6 addresses, to enable or disable stateless IPv6 autoconfiguration, to assign a Fibre Channel IPv4 address and prefix to a logical switch IPFC network interface, and to configure a service port on the CP blade of a Brocade DCX. When run interactively in legacy mode, this command sets the Ethernet IPv4 address, subnet mask, and Gateway on a switch or a chassis. Command usage depends on the type of IP address and on the platform on which the command is run. Some of the platform- and IP address-specific features of the command are outlined below. For complete details, refer to the Fabric OS Administrator's Guide. Configuring IP Addresses using the command line interface 464 Fabric OS Command Reference 53-1002746-01