Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 736

2 portCfgShow 3 Autonegotiated or fixed port speeds of 16 Gbps and 10 Gbps. Speed Displays Auto for auto speed negotiation mode, or a specific speed of 1, 2, 4, or 8 Gbps. This value is set by the portCfgSpeed command. Fill Word (On Active) Displays the fill word setting that will take effect after the next time the port goes offline and comes back Possible values are 0(Idle-Idle), 1(arbff-arbff), 2(Idle-arbff), or 3(A-A then SW I-A).This parameter is set by the portcfgFillword command. Fill Word (Current) Displays the currently effective fill word setting. Possible values are 0(Idle-Idle), 1(arbff-arbff), 2(Idle-arbff), or 3(A-A then SW I-A). This parameter is set by the portcfgFillword command. AL_PA Offset 13 Displays (..) or OFF when the arbitrated loop physical address (AL_PA) on the port is configured to use a 0x0 AL_PA address (default). Displays ON when the address configuration is 0x13 AL_PA. This value is set by the portCfgAlpa command. Trunk Port Displays ON when port is set for trunking. Displays (..) or OFF when trunking is disabled on the port. This value is set by the portCfgTrunkPort command. Long Distance Displays (..) or OFF when long distance mode is off; otherwise, displays long distance levels. This value is set by the portCfgLongDistance command. Values are as follows: LE The link is up to 10 km. LM The link is up to 25 km. L1 The link is up to 50 km. L2 The link is up to 100 km. LD The distance is determined dynamically. LS The distance is determined statically by user input. VC Link Init Displays (..) or OFF when the long distance link initialization option is turned off. Displays ON when it is turned on for long distance mode. This value is set by the portCfgLongDistance command. Desired Distance Displays the desired distance of the port. This field is displayed only when portCfgShow is executed for a single port and would only display for LS and LD long distance mode. Reserved Buffers Displays the reserved buffers for the port. This field is displayed only when portCfgShow is executed for a single port and would only display for LS and LD long distance mode. 708 Fabric OS Command Reference 53-1002746-01