Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 698

2 portCfgEXPort OPERANDS If the Fabric Parameter attribute value is "User configured", the port ID format R_A_TOV and E_D_TOV values display the configured values. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. When invoked without operands, this command displays the usage. The following operands are supported: slot On bladed systems only, specifies the slot number followed by a slash (/). port Specifies the port number. Use switchShow for a list of valid ports. When executed with [slot/]port only, the command displays the current port configuration. -a admin Enables or disables the specified port as an EX_Port. Valid values are 1 (enable as EX_Port), 2 (disable as EX_Port and enable as non-EX_Port). portCfgDefault may also be used to disable EX_Ports. -f fabricid Specifies the fabric ID. Valid values are 1 to 128. -r ratov Specifies the R_A_TOV used for port negotiation. Valid values are 2000 to 120000. This operand is only applicable if the "Fabric Parameter" attribute value is not "Auto Negotiate". -e edtov Specifies the E_D_TOV used for port negotiation. Valid values are 1000 to 60000. This operand is only applicable if the "Fabric Parameter" attribute value is not "Auto Negotiate". -d domainid Specifies the preferred domain ID. For Brocade native mode (-m 0), valid values are 1 to 239. -p pidformat Specifies the Port ID format. Valid values are 0-native, 1-core, 2-extended edge. This operand is applicable only when port mode is set to 0 (native mode). If port mode is not "Brocade Native", the Port ID format displays as "Not applicable". -t fabric_parameter Enables or disables negotiation of the fabric parameters. Valid values are 1 for enable and 2 for disable. -m port mode Specifies the port mode. The -m option enforces the same port mode for all the ports connected to the same edge fabric. If this option is selected, the port mode is compared against the online ports. If the modes are different, an error message is posted, and the command fails. Valid values are as follows: 0 Brocade Native mode. 5 Brocade Network OS fabric mode. -i mode Enables or disables Insistent Domain Id (IDID) for the specified EX_Port. Specify 1 to enable IDID, specify 2 to disable IDID. This command must be issued from a McDATA edge switch attached to a single or dual FCR configuration. 670 Fabric OS Command Reference 53-1002746-01