Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 1145

zoneObjectReplace 2 zoneObjectReplace Replaces zone members. SYNOPSIS zoneobjectreplace oldmember newmember zoneobjectreplace --help DESCRIPTION NOTES OPERANDS EXAMPLES SEE ALSO Use this command to replace the existing member of a zone with a new member. This command can be used to replace members of an alias, but an alias itself cannot be replaced. This command is not applicable for Traffic Isolation (TI) Zones, and Frame Redirect (RD) Zones. For the change to become effective, enable the configuration with the cfgEnable command. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. When an FCS policy is enabled, this command can be issued only from the primary FCS switch. The following operands are required: oldmember Specifies the the zone member that has to be replaced. You can specify WWN or Domain,Index (D,I). newmember Specifies the new zone member with which to replace the old zone member. You can specify WWN or D,I. --help Displays the command usage. To replace zone member: switch:admin> zoneobjectreplace \ "20:00:00:05:1e:a1:af:b2" "10:00:00:05:1e:a1:10:c1" switch:admin> cfgshow Defined configuration: cfg: cfg lsan_m cfg: cfg1 zone2; zone3 zone: lsan_m 20:15:00:05:1e:a2:f9:b1; 20:13:00:05:1e:a2:f9:b1 zone: zone1 2,3; 20:00:00:05:1e:a1:af:b1; zali_1 zone: zone2 5,7; 2,9 zone: zone3 10:00:00:05:1e:a1:10:c1; 20:10:00:05:1e:a9:20:12 alias: zali_1 10:00:00:05:1e:a1:ef:b9; 2,3; 1,11 Effective configuration: cfg: cfg zone: lsan_m 20:15:00:05:1e:a2:f9:b1 20:13:00:05:1e:a2:f9:b1 zoneAdd, zoneCreate, zoneDelete, zoneRemove, zoneShow Fabric OS Command Reference 53-1002746-01 1117