Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 1107

uRouteShow 2 uRouteShow Displays unicast routing information. SYNOPSIS urouteshow [slot/][port] [domain] DESCRIPTION Use this command to display the unicast routing information for a port, as it is known by the FSPF path selection and routing task. The routing information describes how a frame that is received from a port on the local switch is to be routed to reach a destination switch. The following information displays: Local Domain ID Domain number of local switch. In Port Port from which a frame is received. Except for the cases in which you perform a port swap or enable extended-edge PID (PID Format 2) on a switch, the value is equal to the port index field displayed by the switchShow command. Refer to Fabric OS Administrator's Guide for more information regarding the extended edge PID format. Domain Destination domain of incoming frame. Out Port Port to which the incoming frame is to be forwarded. Except for the cases in which you perform a port swap or enable extended edge PID (PID Format 2) on a switch, the value is equal to the port index field displayed by the switchShow command. For port swap operations, the value is equal to the switch port field displayed by the portSwapShow command. Refer to Fabric OS Administrator's Guide for more information regarding the extended-edge PID format. Metric Cost of reaching the destination domain. Hops Maximum number of hops required to reach the destination domain. If the number of hops are different for some multiple equal cost paths (to reach the same domain), then it displays the maximum number. Flags Indicates rout type as either dynamic (D) or static (S). A dynamic route is discovered automatically by the FSPF path selection protocol. A static route is assigned using the command uRouteConfig. Next (Dom, Port) Domain and port number of the next hop. These are the domain number and the port number of the switch to which Out Port is connected. The information provided by this command should match what is provided by portRouteShow and topologyShow. Fabric OS Command Reference 53-1002746-01 1079