Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 236

2 cryptoCfg --failback -EE Performs a manual failback of all CTCs that were failed over earlier to another encryption engine within an HA cluster to a "new" specified encryption engine. This command generates an error if the specified current encryption engine and new encryption engine are not members of the same HA cluster or if the current encryption engine or the new encryption engine are offline. This command is valid only on the group leader. The following operands are required: current_node_WWN [current_slot] Specifies the node WWN of the current encryption engine to which failover occurred earlier, and which is now performing all encryption tasks. On bladed systems, specify the slot number of the current encryption engine. new_node_WWN [new_slot] Specifies the node WWN of the encryption engine to which failback of all CTCs should occur. On bladed systems, specify the slot number of the new encryption engine. --move -container Moves the specified CTC from its currently configured encryption engine to another encryption engine. This command is valid only on the group leader. The EEs must be part of the same encryption group for this operation to succeed, but they do not need to be part of the same HA cluster. This operation permanently changes the encryption engine association of a single CTC from an existing encryption engine to another encryption engine. To move all CTCs hosted on an encryption engine permanently to another encryption engine, use the cryptocfg --replace command. This command is valid only on the group leader. The following operands are required when moving a CTC: crypto_target_container_name Specifies the name of the CTC to be moved. new_node_WWN [new_slot] Specifies the encryption engine to which the CTC should be moved. On bladed systems, specify the encryption engine's slot number. --add -initiator Adds one or more initiators to an existing CTC. An initiator that is added to a CTC facilitates discovering the LUNs of the target as exposed to these initiators. You must still add the initiators when you add the LUN to the CTC to enable access for these initiators. This command is valid only on the group leader. The following operands are required when adding an initiator to a CTC: crypto_target_container_name Specifies the name of the CTC to which the initiators should be added. initiator_PWWN Specifies the initiator port WWN. initiator_NWWN Specifies the initiator node WWN. --remove -initiator Removes an initiator from the specified CTC. This command is valid only on the group leader. The following operands are required when removing anm initiator: crypto_target_container_name Specifies the name of the CTC from which the initiator is to be removed. 208 Fabric OS Command Reference 53-1002746-01