Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 113
cfgcredittools -intport -recover, recover onLrThresh
View all Dell Brocade 6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
bottleneckMon 2 -refresh Refreshes the display to continuously update with fresh data at a certain rate. The refresh rate is equal to the number of seconds specified in the interval. -congestion | -latency Restricts the display to congestion or latency data. If neither is specified, the command displays combined statistics for both types of bottlenecks. --status Displays the details of the Bottleneck Detection configuration for the current (logical) switch. Refer to the command description section for an explanation of the displays. If virtual fabrics are enabled, ports not belonging to the current logical switch are not displayed. --help Displays the command usage. Back-end port credit recovery commands The following operands support backend port credit recovery: --cfgcredittools -intport -recover Configures credit recovery for backend ports. Use one of the following required recovery options to configure credit recovery: -recover onLrOnly Enables the backend port recovery feature in link reset mode. -recover onLrThresh Enables the backend port recovery feature in link reset threshold mode. -recover off Disables the backend port credit recovery feature. -lrthresh threshold Specifies the link reset threshold value. Note that the threshold value set using this option will apply only when the recovery mode is onLrThresh. -fault edgeblade In this mode, the edge blade alone is faulted when the link reset threshold is reached. -fault coreblade In this mode, the core blade alone is faulted when the link reset threshold is reached. -fault edgecoreblade In this mode, the edge blade is faulted the first two times the link reset threshold value is reached. If the threshold value is reached the third time, the core blade is faulted. The -fault option is supported only with the onLrThresh option. --cfgcredittools -intport -check Performs the on-demand detection of credit loss on a given backend port and VC. This operand is optional and exclusive; when you specify this option you cannot use the --cfgcredittools -intport -recover options at the same time. You must specify a port and a VC, separated by a comma. A space before the comma is not permitted. slot/blade_port Specifies the backend port that is to be examined for credit loss. The port number must be the blade port number, since this is a backend port. The blade port number can be located in the "Bpt" column output of the bladePortMap command. Note that the bladeportmap command requires root permissions. Fabric OS Command Reference 85 53-1002746-01