Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 497
ipAddrShow, IPv6 Autoconfiguration Enabled: Yes or No. If enabled, the command displays
View all Dell Brocade 6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 497 highlights
ipAddrShow 2 ipAddrShow Displays IP address information for a switch or control processor (CP). SYNOPSIS ipaddrshow ipaddrshow [-cp cp_number] | -chassis ipaddrshow -slot slot [-eth0 | -eth1 | -gate DESCRIPTION Use this command to display the IP addresses configured in the system. The -cp option displays the IP address for a specified CP on modular platforms, or use the command without arguments to display the IP address on a standalone switch, or the IP addresses for both CPs on a chassis. On a standalone switch, the command displays the following information: • Ethernet IP Address • Ethernet Subnet mask • The Gateway IP Address • Dynamic Host Control Protocol (DHCP): on or Off • IPv6 Autoconfiguration Enabled: Yes or No • Local IPv6 Addresses • IPv6 Gateway address • DHCPv6: on or off On modular platforms, the command displays the following information: For the chassis: • Ethernet IP Address • Ethernet Subnet mask For each CP: • Ethernet IP Address • Ethernet Subnet mask • Host Name • Gateway IP Address If the IPFC network interface is configured for logical switches: • IPFC address for Virtual Fabric ID For each CP: - Backplane IP address - IPv6 Autoconfiguration Enabled: Yes or No. If enabled, the command displays: All local IPv6 Addresses Gateway IP addresses for both CPs Local IPv6 addresses display the following identifiers: • IP Address type: - static - A statically configured IPv6 address. - stateless - Acquired through stateless autoconfiguration. • IP Address state: Fabric OS Command Reference 469 53-1002746-01