Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 54

2 ag --modedisable Disables Access Gateway mode on a switch. After AG mode is disabled, the switch reboots automatically and comes online with default zone access set to "No Access". In order to merge the switch to a fabric, set the default zone to "All Access" and disable/enable the E_Port. --policyshow Displays the supported AG port policies and their status as either enabled or disabled. AG supports four types of policies: • Port Grouping (pg) policy: This policy manages failover of an F_Port to a set of related N_Ports in a port group. • Auto Port Configuration (auto): When this policy is enabled, the AG enabled switch automatically detects available ports and maps F_Ports to N_Ports. Auto port configuration is disabled by default. • Advanced Device Security (ADS) policy. This policy restricts access to the fabric at the AG level to a set of authorized devices. Unauthorized access is rejected and the system logs a RASLOG message. You can configure the list of allowed devices for each F_Port by specifying their Port WWN. Refer to the ag --ads* commands for information on managing advanced device security. ADS policy is disabled by default, which means that all devices can connect to the switch. • WWN Based Load Balancing policy: This policy routes device logins to the least loaded port in the port group to which they are mapped. --policyenable policy Enables the specified port policy for the Access Gateway. When a new policy is enabled, all port related configuration settings are lost. Use the configUpload command to save the current port configuration. Valid policies include the following: pg Enables the port grouping policy. A default port group "pg0" is created, which includes all configured N_Ports assigned to the policy. Enabling port grouping policy disables the Get Fabric Name policy. auto Enables the automatic port configuration policy. When enabled, this policy applies to all ports on the switch. All F_Port to N_Port mapping and port group configurations are ignored. ads Enables the advanced device security (ADS) policy. When enabled, this policy applies to all the ports on the switch. By default all devices have access to the fabric on all ports. wwnloadbalance Enables the device WWN load balancing policy. When this policy is enabled, device logins are sent to the least loaded port in the port group to which they are mapped. These devices are displayed with ag --wwnmapshow as dynamic device mappings. Port Group policy must be enabled before you can enable the WWN load balancing policy. --policydisable policy Disables the specified policy for the Access Gateway. When a policy is disabled, all port-related configuration settings are lost. Use the configUpload command to save the current port configuration. Valid policies include the following: pg Disables the port grouping policy. All port group configurations are deleted. Disabling port grouping policy enables the Get Fabric Name policy. 26 Fabric OS Command Reference 53-1002746-01