Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 97

bladeCfgGeMode 2 bladeCfgGeMode Configures a GbE port or a 10GbE port on the Brocade FX8-24 blade. SYNOPSIS bladecfggemode --set mode -slot slot bladecfggemode --show -slot slot | -all bladecfggemode --help DESCRIPTION NOTES OPERANDS EXAMPLES Use this command to configure the GbE port mode on the Brocade FX8-24 extension blade or to display the configuration. The mode configuration controls which ports are enabled. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command is supported only on the Brocade FX8-24 blade in a DCX or DCX-S4 chassis. This command has the following operands: --set mode Sets the GbE port mode for a specified slot. Valid modes are one of the following: 1g Enables the GbE ports ge0-ge9 (xge0 and xge1 are disabled). 10g Enables the GbE ports xge0 and xge1 (ge0-ge9 ports are disabled). dual Enables the GbE ports ge0-ge9 and xge0 (xge1 is disabled). -slot slot Specifies the slot number for the FX8-24 blade. This operand is required when setting the GbE port mode --show Displays the GbE port mode for the specified slots. -slot slot Displays the GbE port mode for a single slot. -all Displays the GbE port mode for all configured slots. --help Displays the command usage. To configure the Brocade FX8-24 blade in slot 4 in 1G mode: switch:admin> bladecfggemode --set 1g -slot 4 To display the GbE port mode for the Brocade FX8-24 blade in slot 4: switch:admin> bladecfggemode --show -slot 4 bladeCfgGeMode: Blade in slot 4 is configured in 10GigE Mode 10GigE mode: only xge0 and xge1 are enabled (ge0-9 ports \ are disabled) Fabric OS Command Reference 69 53-1002746-01