Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 674

2 portCfg delete tunnel_ID Deletes the specified FCIP tunnel. This command deletes all associated circuits created with the fciptunnel or fcipcircuit commands. Use the portShow command to display all FCIP tunnels and their associated circuits.: fcipcircuit Creates an FCIP circuit on an existing tunnel. Use this command to configure additional circuits. The circuit-specific parameters are optional. The syntax for portcfg fcipcircuit is as follows: portcfg fcipcircuit [slot/]ve_port option circuit_ID options [arguments] [optional_arguments] The following options and arguments are supported with fcipcircuit: create circuit_ID remote_ip_addr local_ip_addr comm_rate [circuit_arguments] Creates an FCIP circuit. You must specify the following parameters when creating an additional circuit: circuit_ID Specifies a numeric identifier for the circuit. The circuit ID is an integer value between 0-9 for both the Brocade FX8-24 and the Brocade 7800. remote_ip_addr Specifies the IP address for the remote end of the FCIP circuit. local_ip_addr Specifies the IP address for the local end of the FCIP circuit. The following two operands are mutually exclusive: comm_rate Specifies the committed traffic rate on the FCIP tunnel in Kbps. The valid range is 10,000 Kbps to 1,000,000 Kbps for 1G ports and 10,000 Kbps to 10,000,000 Kbps for 10G ports. There is no default. Both sides of the tunnel must have matching configurations. -b | --min-comm-rate value -B | --max-comm-rate value Alternately you can set a minimum and a maximum for the committed rate to configure the tunnel for Adaptive Rate Limiting (ARL), which allows for a more effective sharing of bandwidth between applications. The valid range is 10,000 Kbps to 10,000 Kbps for 1G ports and 1,000,000 Kbps to 10,000,000 Kbps for 10G ports. The maximum committed rate can be no larger than five times the minimum committed rate, and both sides of the circuit must have matching configurations. modify [circuit_ID] [circuit_arguments Modifies the properties of an existing FCIP circuit. To modify a circuit, you must specify at least one of the optional circuit parameters for the command to be effective. Any circuit attribute you change with the fcipcircuit modify command affects only the specified FCIP circuit. All other circuits remain unchanged. Refer to fciptunnel create and modify for a listing of optional circuit arguments and their descriptions. delete circuit_ID Deletes the specified FCIP circuit. 646 Fabric OS Command Reference 53-1002746-01