Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 552

2 lsanZoneShow lsanZoneShow Displays logical SAN zone information. SYNOPSIS lsanzoneshow [-s] [-f fabricid] [-w wwn] [-z zonename] DESCRIPTION NOTES OPERANDS Use this command to display the inter-fabric zones or LSAN zones. These zones are normal WWN zones created in FC Router EX_Port-connected fabrics and backbone fabrics. The LSAN zones are identified by the text string "lsan_" in the zone name. Note that the string is case insensitive so "LSAN_" also is valid. The FC Router uses these zones to establish the inter-fabric device import and export policy. The LSAN zones are established by zoning administration in each EX_Port-attached fabric and backbone fabric. Inter-fabric device sharing is allowed between two devices if the LSAN zones defined in their respective fabrics both allow the two devices to communicate; for example, the intersection of LSAN zones in two fabrics define the device sharing policy. The LSAN zones are listed by fabric. Zone membership information (information about the devices in the zone) is provided for each LSAN zone. The default output displays only WWNs of the zone members. Search parameters -f, -w, and -z allow searching for LSAN zones based on fabric ID, WWN of an LSAN zone member, or LSAN zone name. "No LSAN zone found" is displayed if there is no LSAN zone information available at this FC Router. Each LSAN zone entry displays the following: Fabric ID The ID of the fabric in which the LSAN zone was created. Zone Name The zone name. Zone Members The zone members or devices. The default output displays the WWN of the zone members. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command has the following operands: -s state Displays state information for the device. Valid states include the following: Configured Device is configured to be in an LSAN, but the device is neither imported nor exists in this fabric. Initializing Device is in an intermediate state. It is not yet imported into the fabric. EXIST Device exists in this fabric (the fabric of the zone entry). Imported Device has been imported (proxy created) into this fabric. -f fabricid Displays LSAN zones in the specified fabric. 524 Fabric OS Command Reference 53-1002746-01