Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 681
portCfgAlpa, portCfgShow
View all Dell Brocade 6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 681 highlights
portCfgAlpa 2 portCfgAlpa Configures the AL_PA offset on a specified port or range of ports. SYNOPSIS portcfgalpa [slot/]port, mode DESCRIPTION NOTES OPERANDS EXAMPLES SEE ALSO Use this command to set the Arbitrated Loop Physical Address (AL_PA) offset on a port or a range of ports to either 0x0 (default) or 0x13. Changes made by this command are persistent across switch reboots and power cycles. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. The Fabric OS port configuration commands are not supported on FCoE ports. When invoked without operands, this command displays the usage. The following operands are supported: slot For bladed systems only, specify the slot number of the port to be configured, followed by a slash (/). port Specify the number of the port to be configured, relative to its slot for bladed systems. Use the switchShow command for a list of valid ports. mode Specify a value of 1 to set the AL_PA to 0x13. A value of 0 sets the default AL_PA to 0x0. This operand is required. To configure a port with AL_PA 0x0 (default): switch:admin> portcfgalpa 1/3 0 To configure a port with AL_PA 0x13: switch:admin> portcfgalpa 1/3 1 portCfgShow Fabric OS Command Reference 653 53-1002746-01