Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 717

portCfgLossTov 2 portCfgLossTov Enables or disables de-bouncing of signal loss for front end ports. SYNOPSIS portcfglosstov [slot/]port mode DESCRIPTION NOTES OPERANDS EXAMPLES SEE ALSO Use this command to enable or disable the de-bouncing of loss of signal for 100 ms for front end ports. Use portCfgShow to display the current setting. If executed without operands, the command prints the usage. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. On a chassis, this command must be executed on the active CP. This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the port to be configured, relative to its slot for bladed systems. Use switchShow to list valid ports. mode Specify 1 to enable the configuration. Specify 0 to disable the configuration. To enable the configuration on port 1/5 and to display the configuration: switch:admin> portcfglosstov 1/5 1 switch:admin> portcfgshow 1/5 Area Number: 5 Speed Level: AUTO(HW) Fill Word(On Active): 0(Idle-Idle) Fill Word(Current): 0(Idle-Idle) AL_PA Offset 13: OFF Trunk Port ON Long Distance OFF VC Link Init OFF Locked L_Port OFF Locked G_Port OFF Disabled E_Port OFF Locked E_Port OFF ISL R_RDY Mode OFF RSCN Suppressed OFF Persistent Disable OFF LOS TOV enable ON (Output truncated) To disable the configuration on port 1/5: switch:admin> portcfglosstov 1/5 0 portCfgShow Fabric OS Command Reference 689 53-1002746-01