Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 739

portCfgShow 2 NOTES OPERANDS When portCfgShow is issued for a single FCoE port, only the following fields are displayed: Area Number, Speed Level, AL_PA Offset, RSCN Suppressed, and NPIV PP Limit. If the command is issued without operands on a DCX with one or more FCOE10-24 blades, the port parameters that are not valid on the FCoE ports are marked with a dash (-). Refer to the example section for an illustration. You can identify a single port to be displayed by its port number or by its port index number. Port ranges are supported with index numbers or by specifying a slot or a slot range. Use switchShow for a listing of valid ports, slots, and port index numbers. When used without operands, this command displays all persistently disabled ports on the switch. Specifying multiple ports with the index (-i) or slot (-s) option is supported only if PortSwap is disabled. They are not supported on GbE ports and configured F_Port trunks. Use the -i option without a port index argument to display the portSwap status, or alternately use portSwapShow. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. The Fabric OS port configuration commands are not supported on FCoE ports. This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the number of the port to be displayed, relative to its slot for bladed systems. Use switchShow for a listing of valid port numbers. -i index1[-index2] Specifies a port or a range of ports identified by port index numbers. You can specify multiple index ranges separated by a space, for example, -i 33-38 40-60. -f Ignores nonexisting ports. This operand is valid only with the -i option. -slot slot1[-slot2] Specifies a slot or a range of slots. You can specify multiple slot ranges separated by a space, for example,-s 1-3 5-7. ge_port Specifies the number of the GbE Port to be displayed. The GbE ports are numbered ge0 - ge9 on the Brocade FX8-24 blade and ge0 - ge5 on the Brocade 7800 switch. The 10GbE ports on the Brocade FX8-24 blade are numbered xge0 and xge1. Use the switchShow command for a list of valid ports. Use portCfgShow with a GbE port or with one of the optional arguments to display specific FCIP-related parameters. Displays supported on the Brocade 7800/FX8-24 platforms When issued on the Brocade 7800/FX8-24, tunnels and parameters not applicable to these platforms are not displayed. Use the portShow command to display FCIP tunnel and circuit parameters on the Brocade 7800/FX8-24. ipif Displays the IP interface for both ports of the tunnel. IPv6 addresses are supported. iproute Displays the IP route on the specified GbE port. IPv6 addresses are supported. arp Displays the address resolution protocol (ARP) table. Fabric OS Command Reference 711 53-1002746-01