Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 1021

supportShow 2 NOTES OPERANDS EXAMPLES fcip ag dce_hsl crypto FCIP group commands, disabled by default. Access Gateway group commands, disabled by default. DCE group commands, enabled by default. Encryption group commands, disabled by default. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This is a diagnostic command and should only be run for diagnostic support. Output generated by this command may vary by switch configuration and platform. Output may change without notice. This command has the following operands: slot On bladed systems only, specifies a slot number, followed by a slash (/). port1[-por2] Specifies a port or a range of ports for which to display supportShow information. this operand is optional; if omitted, the command displays information for all ports. lines Specifies the number of lines for the portLogDump output. This parameter is valid only with the slot/port parameters. To display debugging information for a single port on a Brocade 5300: switch:admin> supportshow 43 VF Date: Sun Dec 6 05:10:13 PST 2009 Time Zone: America/Los_Angeles Version: Kernel: Fabric OS: Made on: Flash: BootProm: 2.6.14.2 v6.4.0_main_bld09 Tue Dec 1 20:04:36 2009 Wed Dec 2 11:54:49 2009 1.0.15 supportshow groups enabled: os enabled exception enabled port enabled fabric enabled services enabled security enabled network enabled portlog enabled system enabled extend disabled Fabric OS Command Reference 993 53-1002746-01