Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 1068

2 sysMonitor -current Displays current values for a specified class or area. This operand is optional and valid only with the --show option. The output includes the class, area, port number, circuit ID (for the Brocade 7800 and FS8-24 only), Value, State, and Monitoring Status (pause or continue). The State field reports whether the current value is above, in range, or below (info) the configured threshold. If no class or area is specified, this command displays current values for all Fabric Watch classes and areas (not only those configured with this command). The following operands are optional with the --apply, --cancel, and --show options; if omitted, default thresholds are used. -action_level def | cust Configures or displays default or custom action settings. -thresh_level def | cust Configures or displays default or custom thresholds. --config mem | cpu Configures the parameters for monitoring system CPU or memory usage. The following parameters are configurable with this command. -poll Specifies the polling interval in seconds. Valid values are 10 to 3600 seconds. The default value is 120 seconds. This operand is optional. -retry Specifies the number of retries before Fabric Watch takes action. The default value is 3. -limit Specifies a usage limit as percentage of available resources. When used to configure CPU monitoring, specify a value in the 1 to 100 range. When CPU usage exceeds the limit a Fabric Watch alert is triggered. The default CPU limit 75%. When used to configure memory monitoring the limit value must be greater than the low limit and smaller than the high limit. When the limit is exceeded, Fabric Watch sends out a RASlog WARNING message. When usage returns below the limit, Fabric Watch sends a RASlog INFO message. Valid values are in the range between the low limit and 90%. The default value is 60%. The following operands are valid only with --config mem. They provide two additional limits above and below the middle usage limit. -high_limit high_limit Specifies an upper usage limit for memory as percentage of available memory. This value must be greater than the value set by the -limit parameter. The maximum is 90%. When memory usage exceeds this limit, Fabric Watch generates a CRITICAL RASlog message. The default is 80%. -low_limit low_limit Specifies a lower usage limit for memory as percentage of available memory. This value must be smaller than the value set by the -limit parameter. When memory usage exceeds or falls below this limit, Fabric Watch generates an INFO RASlog message. The default for all platforms is 50%. -action actions Specifies the actions to be taken if system resources exceed the specified high threshold or fall outside the boundaries defined by the high and low thresholds. Valid values are snmp, raslog, both, or none. The default is none. If more than one action is specified, actions must be separated by commas. 1040 Fabric OS Command Reference 53-1002746-01