Dell Brocade 6520 Command Reference Supporting Fabric OS v7.1.0 - Page 738

2 portCfgShow Rate Limit Displays ON when ingress rate limit is set on the port or (..) or OFF when the ingress rate limiting feature is disabled. This value is set by the portCfgQos --setratelimit command. The default value is OFF. Credit Recovery Displays ON when Credit Recovery is enabled on the port. Displays (..) or OFF when the feature is disabled. This value is set by the portCfgCreditRecovery command. The credit recovery feature is enabled by default, but only ports configured as long distance ports can utilize this feature. Port Auto Disable Displays On when the Auto Disable feature is enabled on a port. Displays (..) or OFF when the feature is disabled. This feature causes ports to become disabled when they encounter an event that would cause them to reinitialize. This feature is enabled by the portCfgAutoDisable command. The feature is disabled by default. In the single port view, the configured trigger conditions are displayed when the feature is disabled. Refer to the example section for an illustration. F_Port Buffers Displays the number of configured F_Port buffers. Displays (..) or OFF if no buffers are configured. The buffer value is set by the portCfgfPortbuffers command. NPIV PP Limit Displays the maximum number of allowed logins for the port. Displays the default of 126 or the configured maximum. This parameter is set with the portCfgNPIVPort --setloginlimit command. CSCTL mode Displays ON if CSCTL mode is enabled on the port. Displays (..) or OFF if the feature is disabled. This parameter is set with the portCfgQos command. D_Port mode Displays ON when the port is configured as a D_Port; otherwise displays (..) or OFF. Refer to the portCfgDPort command for more information. This parameter is displayed only on on Condor3-based blades that support D_Port capability. D-Port over DWDM Displays ON when dwdm is enabled on that port using the portcfgdport command. This option will be allowed to set only if the link connecting two switches is a DWDM (Dense Wavelength Division Multiplexing) link. Fault Delay Displays the Fault delay value. Displays 0 if the value is R_A_TOV. This is the default. Displays 1 if the value is 1.2 seconds. This value is set by the portCfgFaultDelay command. valid for FC ports only. Compression Displays ON when compression is enabled on a port. Displays (..) or OFF when the configuration is disabled. Compression is enabled by the portCfgCompress command; it is disabled by default. Encryption Displays ON when encryption is enabled on a port. Displays (..) or OFF when the configuration is disabled. Encryption is enabled by the portCfgEncrypt command; it is disabled by default. FEC Displays ON when Forward Error Correction (FEC) is enabled on a port and the port is online. Displays (..) or OFF when the configuration is disabled. FEC is enabled by the portCfgFec command; it is enabled by default. 710 Fabric OS Command Reference 53-1002746-01